High Pressure Rubber Hose Assembly
1. Measurement of the Total Length of the Rubber Hose
The Standard Tolerance Error of Assembly Length
0mm-305mm¡À3mm
305mm-455¡À4mm
455mm-915mm¡À6mm
2. The assembly angle of the two-tip bended rubber hose
Angle relation: Put the rubber hose in one line; one joint is in vertical direction, measure the angle between another joint and the vertical joint clock wise, this angle is assembling angle. As is demonstrated in the above graph, it measures V225. If the connect is vertical, it has no assembly angle.
3. Notice Method of Type Selection
The layers of steel wires braid (wind) in the rubber hose inner layer are indicated with | || ||| 4S and 6S separately.
4. Usage
- Medium: oil, water, air, etc.
- Medium temperature: oil 35¡æ, air 35-50¡æ, water below +80¡æ
|
